The Silver Pulser ^™

Ionic Colloidal Silver Generator

and

Plant Growth Stimulator

Generates Ionic Colloidal Silver using .9999 purity Silver Wires, and plant growth stimulator based on research of Dr.Bob Beck

[MODEL #: ZBB3]

"First Aid Kit of the Future"

as per the research of Dr. Robert (Bob) C. Beck, D.Sc.

Our design of The Silver Pulser is CERTIFIED, APPROVED and Personally ENDORSED by

Dr. Robert (Bob) C. Beck, D.Sc.

Description International Voltage  Requirements Disclaimer Warranty Cost Ordering Research Info
Other Products Free Newsletter What's New? Frequently Asked Questions (FAQ's) Y2K

What is "The Silver Pulser"?

Full instructions about the use and benefits of The Silver Pulser ^™ can be found in the research papers published by Dr. Robert (Bob) C. Beck. For an on-line read of the original Patent # 5,188,738 click here.

Each Silver Pulser is a professionally designed quality device, thoroughly tested on an oscilloscope, and is guaranteed to operate as per the specifications in Dr. Bob Beck's research.

The Silver Pulser is dual function unit being BOTH a Pulser (Plant Growth Stimulator) and Ionic Colloidal Silver Generator.

The Silver Pulser uses only the best .9999 Pure Fine Silver Electrodes. Our Certificate of Compliance for Silver Purity is on file, and can be viewed by clicking HERE.

The Silver Pulser generates the finest quality Ionic Colloidal Silver at a rate of 3-5 ppm (part per million) in 20 minutes for 8-16 ounces of distilled water, with an Ionic Colloid silver particle size that is mostly ions, with colloidal particles in the range of 0.005 - 0.015 microns (Verified on a Scanning Electron Microscope).

To see independent lab tested results of our Ionic Colloidal Silver as an anti-bacterial solution please click HERE.

It has a Bi-Phasic output frequency of ~3.92 Hertz (cycles per second) at a nominal voltage of 27 VOLTS DC peak per cycle (54 Volts Peak-Peak), matching Dr. Beck's specifications exactly. This device for research purposes only. Before using, consult your professional health practitioner or Medical Doctor.

---

Unique Features:

• Fully Endorsed and Approved by Dr. Robert C. Beck, D.Sc. (Dr. Beck uses our Silver Pulser personally.)

• A unique circuit design allows the The Silver Pulser to operate from a single 9 Volt alkaline battery. Dr. Beck's original plan actually calls for the use of 7 batteries in his design. Our state-of-the-art electronic design utilizes a proprietary DC-DC converter which boosts the output of the 9 Volt battery to the 27 Volts DC required by the The Silver Pulser. Our unique design is fully endorsed by Dr. Beck.

• Constant-Voltage Output - Unique circuitry maintains the required 27 Volts output regardless of battery voltage or other input power (like from an AC-DC Wall adapter, Automobile Battery, or Solar Panel). Thus, as the battery runs down or if the input voltage fluctuates, the output will maintain the 27 Volts. No other device using either 3 x 9 Volt batteries or voltage triplers can offer this very important feature.

• We use only the purest, Fine Silver Wire Electrodes, 4 Nine Grade (.9999 pure) for the Ionic-Colloid Silver production.

• The Plant Growth Stimulator Probes are of the highest quality and heavy GOLD plated.

• Our Electrical Circuit Boards are GOLD Plated for extreme reliability and workmanship.

• All electrical wire connections made with Food Grade solders and fluxes for the highest in safety and purity.

• 3 Year Parts and Labour Warranty on all internally mounted components. Replacement Fine Silver Wire Electrodes and Probes are available.

The Unit:

(To download the Operating Manual for this device in Adobe Acrobat PDF format, please go to our Downloads page by clicking on this link: http://www.sota-inc.com/downloads.htm)

The Silver Pulser is housed in an attractive "PC-Bone" (Pantone "Warm Grey 1") coloured ABS plastic box, with a built-in compartment for the 9 Volt battery. A slide-off lid allows you to change the battery easily. A Thumbwheel Switch Control Knob on the end turns The Silver Pulser on and off and varies the intensity of the "Plant Growth Stimulator Probe" output. Two flashing Green and Red LED lights on the left-side on the unit indicates there is a correct "Stimulator" output. When these two flashing lights dim or go out, it's time to get a fresh battery. In addition, the two Green and Red LED lights on the right-side of the unit are used for the Ionic-Colloidal Silver generation. Green means OK, Red indicates the conductivity has gone too high.

The Silver Pulser has three jacks, one for plugging in the Fine Silver Wires, another for the GOLD Plant Growth Stimulator Probes, and a third for hooking up an AC-DC Wall Adapter so you don't have to go through batteries. Each of the wire cords are about 6 feet (2 metres) long and are very flexible. We also include Cotton Sleeves to put over the Plant Growth Stimulator Probes for helping to maintain a good connection when moistened. (Hint: Use a Salt Water solution or a conductive gel used on T.E.N.S. pads for better conductivity!)

The Silver Pulser is packaged in a lidded white cardboard "die-cut mailer" box for easy storage.

Electronics:

The Silver Pulser is designed as per the research by Dr. Bob Beck, and is fully endorsed. We have improved on the design with added features. These changes by no means alter the effectiveness of the unit. Our electronic design is unique and efficient making the unit very portable and light-weight. There's even a provision for adding an external power source to save on batteries, such as an AC-DC Wall Adapter which you can purchase from any Radio Shack® store.

Specifications:

• Battery Voltage: 9 Volts DC (Alkaline Battery)
• Optional Input Voltage: 6 - 12 Volts DC @300mA Wall Transformer/Adapter, Automobile Battery, or Solar Panel.
• Output Voltage at Colloidal Silver Probes: 27 Volts DC, +/- 1 Volt
• Output Current: 20 milliamps Maximum when Silver Wires are shorted
• Ionic-Colloid Silver Production: 3 - 5ppm (parts per million) for 20 minutes for 8-16 ounces distilled water.
• Ionic-Colloid Silver Particle Size: Mostly ionic, with colloidal particles in the range of 0.005 - 0.015 microns when made as directed.
• Ionic-Colloid Silver Colour: Optional. Milky-White when using salt (not recommended) as an electrolyte (faster production), or preferred Golden Colour when using no electrolyte (but takes 10 times longer to make).
• Silver Wire Life: Can make approximately 80 gallons of 3 - 5 ppm ionic-colloidal silver per set of Silver Wires, when made as directed.
• Output Voltage at Gold Stimulator Probes: 27 Volts (Peak per Cycle, 54 Volts Peak-Peak) Bi-Phasic at ~3.92 Hertz (cycles per second) +/- 1 Hz. To see the actual output waveform from the oscilloscope, please click HERE. Note the extremely square and symmetrical waveform; free of any spikes or artifacts. The frequency as measured in this unit is 4.040 Hz (cycles per second), and the peak-to-peak output voltage is measured at 54.4 Volts (27 Volts peak per half cycle). This conforms to Dr. Beck's specifications exactly.
• Output Current at Gold Stimulator Probes: ~25 milliamps maximum when probes shorted and Control Knob on full intensity.

Dimensions:

The Silver Pulser is 2.25" wide x 3.75" long x 1" thick (6 cm wide x 9.5 cm long x 2.5 cm thick). Casing is high-impact ABS plastic. The Silver Wires are 14 AWG (1.63mm or 0.064" dia.) x 8" long (1.5 mm diameter x 20.3 cm long) and are constructed of only Pure Fine (.9999 pure) Silver Wire. Plant Growth Stimulator Probes are 1/8" diameter x 1.25" long (3mm diameter x 3.8 cm long) and are constructed of heavy plated GOLD over SILVER over COPPER.
Weight of The Silver Pulser unit is only a few ounces - very lightweight. Case is black in colour.

Each Silver Pulser comes complete with:

• The Silver Pulser unit

• Operating Manual
• Additional Documentation (Take Back Your Power manual) for Researchers (which is mailed to you separately)
• .9999 (4 Nine Grade) Pure Fine Silver Wire Electrodes. Our Certificate of Compliance for Silver Wire Purity is on file, and can be viewed by clicking HERE.
• High Grade GOLD Plated Plant Growth Stimulator Probes
• Two (2) Velcro®/Neoprene Straps
• One (1) Scotchbrite® scrubber pad
• Bag containing Celtic Sea Salt
• One (1) 2 oz. Dark Glass Dropper Bottle
• Two (2) pair Cotton Probe Sleeves
• Cardboard "die-cut mailer" Storage Box
• 3 Year Parts and Labour Warranty on internally mounted components

International Voltage (220 or 240 Volt Mains) Requirements:

The Silver Pulser can be operated by an external power source like an AC-DC Wall Adapter, Automobile Battery, or Solar Panel. If you wish to power the Silver Pulser with a wall transformer, your options are:

1. Purchase SOTA's International / Universal Wall Adapter. Please see our Products page for details.

2. Purchase a local Wall Adapter with: Input 220VAC or 240VAC, 50 Hz Mains, 6-12 Volt DC output, 300mA (milli-amps) or more, Centre Positive, 2.1mm Plug.

3. Additionally, the Silver Pulser may also be operated directly from a 12 Volt DC Battery like via an automobile cigarette lighter. You will need to purchase an adapter cord which plugs into the cigarette lighter and has a Centre Positive, 2.1mm Plug, like a Radio Shack® #270–1528C.

Disclaimer:

What about a Warranty?

How much is "The Silver Pulser"?

Our Policy at SOTA: "We encourage you to educate yourself before purchasing any of our units. When ill, it's easy to make a decision in desperation rather than based on information." "We are a company that believes in self-responsibility for ourselves and our customers. Once you purchase and use our units we cannot take responsibility for your decision." "If, however, the unit has not been used at all, we will refund the full purchase price within 30 days of purchase." "Thank-you for your understanding." Please note: Personal cheques will be held for 30 days to allow funds to clear.

How can I Order "The Silver Pulser"?

   
(Visa, MasterCard, Discover Card, or Money Order)

Please note: Personal cheques will be held for 30 days to allow funds to clear.

Call toll free in North America 1-800-224-0242 Or: Tel: 1 + (250) 814-0046 Fax: 1 + (250) 814-0047 For Canadian inquiries/orders write to: SOTA Instruments Inc., P.O. Box 1269, Revelstoke, BC, Canada V0E 2S0 For United States inquiries/orders write to: SOTA Instruments Inc., P.O. Box 866, Pt. Roberts, WA 98281-0866 Or e-mail to anybody@sota-inc.com NOTE: This is NOT a secure page. Please DO NOT e-mail your credit card numbers or other sensitive data. Thank-you!

Where can I get more information on Dr. Robert (Bob) C. Beck's research?

Other Interesting Alternative Health Products:

Please click HERE for SOTA's current Products...

Please click HERE for Sharing Health From the Heart Inc.'s current Products...

---

Free Newsletter Subscription:

Please click HERE to receive a free newsletter from Sharing Health From the Heart Inc. Learn about cutting-edge research on: how electricity is used to enhance health; holistic health practices; spiritual, mental, emotional and physical steps to abundant health; and much more.

What's New?

Please click HERE for our What's New? page...

Frequently Asked Questions (FAQ's):

Please click HERE for our Frequently Asked Questions (FAQ's)...

Y2K (The Year 2000)

The Silver Pulser is fully Y2K compliant. In the event of a power outage here are some options for powering the Silver Pulser other than normally with its 9 Volt Alkaline Battery:

1. The Silver Pulser may be operated directly from a 12 Volt DC Battery like via an automobile cigarette lighter. You will need to purchase an adapter cord which plugs into the cigarette lighter and has a Centre Positive, 2.1mm Plug, like a Radio Shack #270–1528C.
2. The Silver Pulser can be powered by a suitable solar panel. Keep in mind that most solar panel generators are used to re-charge a battery which in turn operates the device. Therefore we suggest you use a solar panel to re-charge a (preferably a sealed Gel-Cel type) 12 Volt DC automobile battery, then run the Silver Pulser directly from the battery. You will need to use a cord which has alligator clips on one end to attach to the battery terminals, and the appropriate Centre Positive, 2.1mm Plug on the other end to plug into the Silver Pulser. Be careful with polarity! This type of cord with alligator clips on one end is probably not readily available, therefore you will to need to buy a cord and cut off the end that normally goes into the cigarette lighter, and solder your own set of alligator clips. Use a black and red alligator clips so you ensure polarity is correct each time you connect the circuit.
3. If you wish to operate the Silver Pulser directly from a solar panel you will need to use a 12 Volt DC output panel that is capable of supplying at least 1 Amp. The Silver Pulser's initial starting demands may require a higher output solar panel. That is why it is preferable to use a charged 12 Volt DC battery instead.

This page was created using GEKKO talents!
Webmaster: Russell J. Torlage, CTech
Last updated: November 5, 1999

SOTA's Home Page Top of Page